Page 10 of 14
Re: ZX Printer Belt
Posted: Sun Apr 29, 2018 6:50 am
by Paul
gammaray wrote: ↑Sun Apr 29, 2018 5:28 am
Tears of joy.
I second this!
YEAH!
Re: ZX Printer Belt
Posted: Sun Apr 29, 2018 3:48 pm
by mhudson52
Man, that is great to see! And I thought I had your only stylus. Please send a close-up of how you attached them to the posts.
Without your generous help it couldn't have happened!
Mike
Re: ZX Printer Belt
Posted: Sun Apr 29, 2018 6:46 pm
by FrancoisLanciault
mhudson52 wrote: ↑Sun Apr 29, 2018 3:48 pm
Man, that is great to see! And I thought I had your only stylus. Please send a close-up of how you attached them to the posts.
I looked in my junk box and I found the remains of my second printer belt. It was just too tempting...
As I said, I just melt the top of the spigot to hold the stylus in place. Not a very nice solution but good enough for à try run.
Re: ZX Printer Belt
Posted: Wed May 02, 2018 7:50 pm
by mhudson52
The 0.01" music wire has arrived, and have done the measurements of the stylus. Will hopefully get a couple of prototypes done this evening.
Re: ZX Printer Belt
Posted: Fri May 04, 2018 1:03 am
by mhudson52
After several failures at coming up with a method of reproducing the stylus I have finally arrived at a reliable method.
Here is a photo of a "phase one" prior to trimming the legs and bending the ends. I'm sure that part will be fun as well.
Re: ZX Printer Belt
Posted: Fri May 04, 2018 3:38 pm
by msch
FrancoisLanciault wrote: ↑Sun Apr 29, 2018 4:19 am
...
You'll be happy to look at this
...
Great - marvelous progress!
Re: ZX Printer Belt
Posted: Sun May 06, 2018 1:45 am
by mhudson52
Making excellent progress on reproducing the printer belt stylus. The one on the left circled in red is the original.
Re: ZX Printer Belt
Posted: Sun May 06, 2018 9:19 am
by Paul
I can't see much difference.
Great job. Love to see how they print. Kind regards Paul
Re: ZX Printer Belt
Posted: Sun May 06, 2018 3:35 pm
by mhudson52
Thanks, Paul. Making them is about as tedious as picking fly poop out of black pepper
, but now have a process that is fairly repeatable. They may require a tiny bit of tweaking but not much.
Re: ZX Printer Belt
Posted: Sun May 06, 2018 5:05 pm
by McKlaud
They look great! Unfortunately my ZX Printer has got a cooked ULA and no replacement available