Search found 960 matches
- Sun Apr 01, 2018 8:17 am
- Forum: Hardware
- Topic: Tape read/write on expansion port?
- Replies: 24
- Views: 1305
It's for my Lambda 8300 which does not work with neither ZXpand nor ZXblast. With ZX81 compatible ROM or with original ROM? There is a simple Addon with a vdrive for the ZX81 which will work out of the Box with Lambda Hardware. With ZX81 compatible ROM the Software should run immediately as well. K...
Sorry I am on my mobile with only edge connection. A quick search on this forum or the tlienhard forums should give you the precise answer. It takes me approximately five minutes to load the empty reply page. Tomorrow evening I can answer when I have wifi again. I am very interested in the print dat...
I wouldn't buy a printer in the hope to get a non broken belt. It's hopeless. I can tell you a little about the teeth: They are like a Trapez, 2mm at the base and one mm at the top flat part. Height one mm. And from my experience print the belt in a circle with the teeth vertical. not straight line ...
While this is a funny idea, please dont do it. the original 16k rampacks draw too much current to have tree of them attached. And be aware that the bus is not allowed to be like a star because its going to be flooded with reflections. Bus wires need to go go from port 1 to port 2 then to port 3. Eac...
- Tue Mar 13, 2018 10:00 pm
- Forum: Development
- Topic: do we still use UHF modulators ?
- Replies: 17
- Views: 852
Would Modulator compatibility raise the cost of the ULA replacement significantly? Or is it the time required for development that makes you ask? It would be better have at least one replacement ULA that could be a repair for Zeddies with broken ULAs and drive its Modulator. Would it be possible to ...
- Wed Feb 21, 2018 10:39 pm
- Forum: Hardware
- Topic: Problem with my new ZXpand+
- Replies: 20
- Views: 1345
https://www.sellmyretro.com/uploaded/img/25903_IMG_3741.jpg In centre bottom dark thing just below and to the left of the diamond shaped chip... Regards Andy In order to draw the attention from sirmorris ;) The diamond is actually a square isn't it? I don't own a diamond but I have some squares for...