Sinclair ZX80 / ZX81 / Z88 Forums

Hi, The ZX81 emulator's 'ZX Printer' output is a BMP image. Is there any chance that output can be Standard ASCII, instead of an image? THX! Although this sounds like it should be simple, there are a number of difficulties. EightyOne could intercept the bytes in the ZX Printer Buffer as they are ab...

Hi Paul

I've sneaked in a change for this at the last minute before releasing v1.39. Hopefully it does what you need.

I've just released version 1.39 of EightyOne. This version adds support for the QS Hi-Res board, along with example programs for it. It also includes documentation on the various hardware interfaces supported by the emulator. See the release history file (now accessible via the Help menu) for full d...

I would need to set up a comparable configuration to see if I can reproduce the issue. I've noted it for a future release.

When you say "goes wrong", in what way does it go wrong? I just tried loading a 2K block to address 50000 and it seemed to work fine. Could you provide the step-by-step instructions of the problem that I can follow to reproduce the issue you are seeing.

Reboot wrote: ↑Thu May 11, 2023 7:56 am I noticed there is a memotech HRG emulation edge fail case that only occurs when NTSC=1 (60Hz checkbox).

This should now be fixed in the newly released v1.38!

With "v1.37", a connected USB device (Simple 8-bit Data storage) will not be activated via the selection. But this procedure works with "V0.43b" or "V0.52". I found a change from v0.52 to v1.0 which I think was the cause, and it now seems to work. I have not exhausted tested the drive functionality...

Thanks. I have followed your steps with v0.52, v1.0 and v1.0a and it seems the functionality was broken way back in v1.0 (10th March 2008!)...

Version 1.37 has just been released and is available from here . Hello, A quick question, about my small problem: My tests with Eightyone have shown that only after using the Eightyone version e.g. "V0.43b" or "V0.52" even in the latest "Version 1.37", the 8-bit Volume are recognized (connected to ...

Reboot wrote: ↑Thu May 11, 2023 7:56 am I noticed there is a memotech HRG emulation edge fail case that only occurs when NTSC=1 (60Hz checkbox).
The attached file is best run at speed32.

Thanks for the file. I was able to reproduce the issue and have a fix lined up for inclusion in the next release.