Saved programs too noisy

XavSnap · Post by **XavSnap** » Wed Feb 26, 2020 2:40 am

Hi Aurelbois,

You forgot to type the wiring diagram in a <code> box..

Is it true ?

1024MAK · Post by **1024MAK** » Wed Feb 26, 2020 9:12 am

To go from mono to stereo, connect both channels together in the stereo plug. Make sure you attach a label saying “both channels linked together”.

To go from a two channel (stereo) plug to mono, connect to the left channel only in the stereo plug and wire to the mono plug. The 0V/GND/screen obviously also needs to be connected. Don’t make any connection to the right channel in the stereo plug. Note that this assumes that the output device is driving both left and right channels with the same signal.

Mark

Aurelbois · Post by **Aurelbois** » Wed Feb 26, 2020 3:15 pm

Hi XavSnap
Very good, that's what I wanted to display. Thanks
I used that circuit to create a cassette tape from a wave file using Windows 7

Aurelbois · Post by **Aurelbois** » Sun Mar 15, 2020 3:53 pm

CarolineZX81 wrote: ↑Sat Feb 22, 2020 9:40 pm Hi Xavsnap.

I will adjust the volume setting and see if that helps!

Any update on your problem
Thanks

Sinclair ZX80 / ZX81 / Z88 Forums

Saved programs too noisy

Re: Saved programs too noisy

Re: Saved programs too noisy

Re: Saved programs too noisy

Re: Saved programs too noisy