Page 5 of 5
Re: Lambda 8300/Power 3000 Mutlirom
Posted: Wed Sep 18, 2013 11:37 am
by sascha2000
Hello,
I must admit that I have no experience with ribbon cable & sockets.
For me the described procedure with the pipe wrench worked very well ... and lasts only some minutes. Maybe this is owed the quality & size of the "V"-pins .....
Regards
Sascha
Re: Lambda 8300/Power 3000 Mutlirom
Posted: Thu Oct 10, 2013 1:32 am
by sascha2000
Hello,
a new draft version of the manual is now available:
http://www.eightbits.de/Manual-v011.pdf
Regards
Sascha
Re: Lambda 8300/Power 3000 Mutlirom
Posted: Tue Oct 15, 2013 10:54 pm
by TMAOne
sascha2000 has asked me to post these pictures I took of the wiring for the MultiROM in a Zeddy. Note that the two reset wires (for the ZX81 and for the ROM board) are connected together and extended out to a wire I simply touch to the modulator shield or the heat sink (ground) to do the reset. Not elegant, but it works.
- HPIM1544_2.jpg (43.42 KiB) Viewed 21849 times
- HPIM1545_2.jpg (50.1 KiB) Viewed 21849 times
Installed in my Lambda, the ZX81 compatible ROM runs great. I have used it to run the machine code game Deflection I posted at
viewtopic.php?f=4&t=1201 (There's a picture of a screen there now too.)
- HPIM1547_2.jpg (71.69 KiB) Viewed 21849 times
I tested SAVE with the ZX81 compatible ROM image and then LOAD back to a real ZX81, which seems to work fine. Can't do that with a native Lambda!
Thanks Sascha, this is a great toy.
Ian
Re: Lambda 8300/Power 3000 Mutlirom
Posted: Thu Mar 03, 2016 3:59 pm
by RWAP
Are the multiroms now available to buy?
Re: Lambda 8300/Power 3000 Mutlirom
Posted: Thu Mar 22, 2018 8:06 am
by mrtinb