Page 13 of 13

Re: ZX Spectrum Issue 3 repair

Posted: Sat Jun 03, 2017 2:59 pm
by Tezz
I checked the pins and tracks for IC3 and they looked ok so I tried 74HCT157N but no change. I went to take it out of the socket and it was totally wedged in, I couldn't use a puller or lever it out, I've never seen that occur before. Eventually forced it out of the socket with leverage which lifted the contacts out of the socket too. Perhaps there was a problem with the socket after all. I've now removed the broken socket and after some effort I've also removed IC4. Tracks and pads look fine fortunately so I'll install sockets and try the two HCT157Ns next.

Re: ZX Spectrum Issue 3 repair

Posted: Sat Jun 03, 2017 5:11 pm
by Tezz
Success! I installed the two sockets for IC3 / IC4 and used one of the new 74HCT157N chips along with the SN74LS157N that was originally socketed, I then installed a lower RAM module and the board is finally working :) So.. it looks like either that socket or the soldered SN74LS157N was the problem. I will need to buy a new 74HCT157N for the upper RAM upgrade as the one I had to force out of the old socket was too bad to reuse. One of the EAR or MIC sockets has a broken clip so I'll need to replace that as well as the capacitors to make sure that I've not just done half a job.

Re: ZX Spectrum Issue 3 repair

Posted: Sat Jun 03, 2017 5:20 pm
by 1024MAK
Well done 8-) :D

Another Speccy brought back to life :D

Mark

Re: ZX Spectrum Issue 3 repair

Posted: Sun Jun 04, 2017 10:47 am
by Tezz
Thanks for your advice again Mark.