;In the page 111 of the book linked below
;has a very fast LM routine for PLOT/UNPLOT:
;http://www.zx81.megahospedagem.com.br/f ... os/ulm.zip
;The book is in Portuguese language, but the
;routine is ready for use.
;Before call it, set the registers B and C with X and Y,
;respectively, and set register A with $40 for
;PLOT, or with $00 for UNPLOT.
This is supposed to be a fast PLOT replacement routine.
Personally, I don't see much difference. That may be because of the overhead required to set up a PLOT command from BASIC, before the USR call. It might work a lot better from within a purely MC application, bypassing any ROM PLOT/UNPLOT calls. I've included a couple of demos.
One caution, be aware that the routine is self-modifying using a LD (PLOT+1),A, where (PLOT+1) is an address located WITHIN the routine . So be careful if you use it and move it to a different address.
- Rapid Plot.zip
- Program, scans & demos
- (720.55 KiB) Downloaded 679 times
I'm attaching this mod with demo.
- Screen shot
- Screen.jpg (2.27 KiB) Viewed 3547 times
- Rapid Plot (64x48).zip
- 64x48 PLOT routine
- (2.35 KiB) Downloaded 202 times