Page 4 of 4
Re: My zx80/zx81 clon is working
Posted: Fri Oct 27, 2017 7:26 pm
by wilco2009
Thanks
Re: My zx80/zx81 clon is working
Posted: Thu Nov 23, 2017 10:27 pm
by axtelle
Hi Wilco,
Out of curiosity where did you source the grey foam strips for the feet from ?
They look just like the originals and a friend has been asking about them.
Thanks,
Ellis.
Re: My zx80/zx81 clon is working
Posted: Fri Nov 24, 2017 5:50 pm
by wilco2009
It is Eva rubber.
This type of material is sold in sheets in paper shops or craft stores.
Re: My zx80/zx81 clon is working
Posted: Sun Nov 26, 2017 1:44 am
by axtelle
Thank you Wilco.
Re: My zx80/zx81 clon is working
Posted: Sun Feb 02, 2020 12:05 am
by wilco2009
Hi guys!
I just found a way to resolve an incompatibility in my zx80 clone design.
The problem was that some models of 74LS00s used as IC11, inverts the video output.
To fix it is necessary to insert a 47K resistor between pin 1 and pin 14 of IC 11 to make a pull-up in the pin 1.
All the information about my clone:
https://wilco2009.blogspot.com/2017/07/ ... ading.html