Replacement connectors
Replacement connectors
Are the connectors used for Tape/Power on the ZX80/81, and Tape on the Spectrum still available from anywhere, as I have a few machines that could do with them replacing.....
Cheers.
Phill.
Cheers.
Phill.
Re: Replacement connectors
or these maybe ? just chuck the nut in the spare parts bin
http://uk.farnell.com/cliff-electronic- ... dp/8044961
http://uk.farnell.com/cliff-electronic- ... dp/8044961
what's that Smell.... smells like fresh flux and solder fumes...
Re: Replacement connectors
That does indeed look like them IIRC the ZX ones have a thread on them always wondered why !Andy Rea wrote:or these maybe ? just chuck the nut in the spare parts bin
http://uk.farnell.com/cliff-electronic- ... dp/8044961
Cheers.
Phill.
Re: Replacement connectors
I can now comfirm that these do indeed fit, if you snip one of the legs off, should work fine in a Spectrum too.Andy Rea wrote:or these maybe ? just chuck the nut in the spare parts bin
http://uk.farnell.com/cliff-electronic- ... dp/8044961
Cheers.
Phill.
Re: Replacement connectors
Hi,
I wonder if these are really the right parts.
They are the CL1382 parts (S6/BB). From the datasheet attached by farnell these are supposed to be used with wires.
We would need S6/BB PC for printed circuit boards which are CL1384.
These can be found elsewhere (e.g. mercateo).
Did anybody order these and confirm this?
Thanks
Paul
I wonder if these are really the right parts.
They are the CL1382 parts (S6/BB). From the datasheet attached by farnell these are supposed to be used with wires.
We would need S6/BB PC for printed circuit boards which are CL1384.
These can be found elsewhere (e.g. mercateo).
Did anybody order these and confirm this?
Thanks
Paul
In theory, there is no difference between theory and practice. But, in practice, there is.
Re: Replacement connectors
I'll check when I get home, but the CL1382 sockets actually fit the oles on the ZX81 mainboard, I also believe that the originals where also the ones designed to have wires soldered to them. I have an unbuilt kit (at home so can check this).Paul wrote:Hi,
I wonder if these are really the right parts.
They are the CL1382 parts (S6/BB). From the datasheet attached by farnell these are supposed to be used with wires.
We would need S6/BB PC for printed circuit boards which are CL1384.
These can be found elsewhere (e.g. mercateo).
Did anybody order these and confirm this?
Cheers.
Phill.
Re: Replacement connectors
You are right about the part number - I have had to modify the part in order to fit the zx80 board. I can't find the correct part at any of my uk suppliers.
C
C
Re: Replacement connectors
When you say 'modify' what exactly do you mean, the ZX80/81/Spectrum ones only have 3 legs, where as the farnell ones have 4, but all I needed to do was to cut the 4th leg off and it fit the ZX81 perfectly.sirmorris wrote:You are right about the part number - I have had to modify the part in order to fit the zx80 board. I can't find the correct part at any of my uk suppliers.
Cheers.
Phill.
Re: Replacement connectors
Pop off the 4th leg and trim the legs so they're thinnerer.sirmorris wrote:I have had to modify the part in order to fit the zx80 board.