Cleaning ZX81 16k RAM pack and edge connector

Discussions about Sinclair ZX80 and ZX81 Hardware
Post Reply
hinotor1
Posts: 7
Joined: Wed Feb 20, 2019 1:33 pm

Cleaning ZX81 16k RAM pack and edge connector

Post by hinotor1 »

Hi All!
I wondered if anyone would share their personal advice on the best methods for cleaning the 16K RAM pack and the edge connector on the zx81.
Thanks! :)
User avatar
1024MAK
Posts: 5101
Joined: Mon Sep 26, 2011 10:56 am
Location: Looking forward to summer in Somerset, UK...

Re: Cleaning ZX81 16k RAM pack and edge connector

Post by 1024MAK »

First, to remove any oils or grease (from people handling it) clean the edge-connected and the socket with IPA (Isopropyl alcohol) using a toothbrush (but not one you use for your teeth, buy a new one for this). Be careful and don’t splash any IPA in your eyes. Then use a cloth or paper towel to finish off.

If the edge-connector on the ZX81 (or indeed, any edge-connector where tinned finger contacts are used (a dull silver colour)), needs further work, use either a eraser designed to remove ink (NOT one designed to remove pencil lead) or a ‘PCB cleaning scrub block’.

Alternatively use a ‘fibreglass abrasive pencil’ / ‘glass fibre cleaning pen’.

In all cases, make sure you don’t breathe in the dust that is produced. Collect up the dust and dispose of it properly as the dust will contain lead.

Finish up with another clean using IPA.

When cleaning, you are looking to just take the surface layer off so that you get a nice shiny silver colour. If you get down to the copper layer, stop cleaning.

Mark
ZX81 Variations
ZX81 Chip Pin-outs
ZX81 Video Transistor Buffer Amp

:!: Standby alert :!:
There are four lights!
Step up to red alert. Sir, are you absolutely sure? It does mean changing the bulb :!:
Looking forward to summer later in the year.
paul ron
Posts: 29
Joined: Wed Oct 04, 2017 3:37 am
Location: nyc

Re: Cleaning ZX81 16k RAM pack and edge connector

Post by paul ron »

To clean female edge connectors that are heavily oxidized, I fold a piece of wet dry 400 abrasive paper to form a male and push it in n out a few times.

Cleaning the males, use a pencil eraser n go over the fingers till they are nice n shinny again.
The more you say the less people hear.
Post Reply