Just doing a bit of backward engineering and I discovered that two of my ZX81 boards have a 330 ohm resistor (orange-orange-brown; front and center in the photos below) that isn't on the schematics.
This resistor is connected to the node where X1 and C6 are connected. The other terminal is to ground.
Anyone know the history behind this mod?'
Thanks, Dan
Mystery 330 ohm resistor connected to X1
Mystery 330 ohm resistor connected to X1
Dan Moore
Portland, Oregon, USA
Portland, Oregon, USA
Re: Mystery 330 ohm resistor connected to X1
Zoom x5:
You can remove the component.
Maybe a montage error!You can remove the component.
Xavier ...on the Facebook groupe : "Zx81 France"(fr)
- 1024MAK
- Posts: 5118
- Joined: Mon Sep 26, 2011 10:56 am
- Location: Looking forward to summer in Somerset, UK...
Re: Mystery 330 ohm resistor connected to X1
Pure speculation, but maybe this was an attempt to improve the reliability of the oscillator circuit when a particular batch of 6.5MHz resonators were being used.
Dan, which issue boards are those. I can see that they are not Sinclair ZX81 issue one boards, so are they Sinclair ZX81 issue three boards or are they Timex Sinclair TS1000 issue three boards?
The only TS1000 that I have, uses a Sinclair ZX81 issue three board and does not have that extra 330Ω resistor.
There are photos of a TS1000 using a Sinclair ZX81 issue three board with the extra 330Ω resistor here. Notice that this has chips with a 1982 date code.
And a photo of a Timex Sinclair TS1000 issue three board without the extra 330Ω resistor here. This board has chips with a 1983 date code.
Mark
Dan, which issue boards are those. I can see that they are not Sinclair ZX81 issue one boards, so are they Sinclair ZX81 issue three boards or are they Timex Sinclair TS1000 issue three boards?
The only TS1000 that I have, uses a Sinclair ZX81 issue three board and does not have that extra 330Ω resistor.
There are photos of a TS1000 using a Sinclair ZX81 issue three board with the extra 330Ω resistor here. Notice that this has chips with a 1982 date code.
And a photo of a Timex Sinclair TS1000 issue three board without the extra 330Ω resistor here. This board has chips with a 1983 date code.
Mark
ZX81 Variations
ZX81 Chip Pin-outs
ZX81 Video Transistor Buffer Amp
Standby alert
There are four lights!
Step up to red alert. Sir, are you absolutely sure? It does mean changing the bulb
Looking forward to summer later in the year.
ZX81 Chip Pin-outs
ZX81 Video Transistor Buffer Amp
Standby alert
There are four lights!
Step up to red alert. Sir, are you absolutely sure? It does mean changing the bulb
Looking forward to summer later in the year.
Re: Mystery 330 ohm resistor connected to X1
I've seen similar on zx81 isue 3 boards with red solder mask but in my case they were 1K resistors
Andy
Andy
what's that Smell.... smells like fresh flux and solder fumes...
Re: Mystery 330 ohm resistor connected to X1
Both of them are issue 3 "ISS 3". Both have red solder mask on the underside, but one has a white top silkscreen and the other has a yellow silkscreen. The silkscreen is virtually identical except the yellow one has the number 8243 near the oscillator circuit.
Yeah, I figured as much, suspecting it was a bodge to help the ceramic resonator.
If the ZX81's internal oscillator circuit is like the Spectrum's (which is published in Chris Smith's book: "The ZX Spectrum ULA") then it's an design that I haven't seen used before. Creating a similar circuit in CMOS wouldn't be easy (for me anyway). Better off just ignoring pin 35 and putting a Pierce oscillator on the substrate -- just like Andy did.
Yeah, I figured as much, suspecting it was a bodge to help the ceramic resonator.
If the ZX81's internal oscillator circuit is like the Spectrum's (which is published in Chris Smith's book: "The ZX Spectrum ULA") then it's an design that I haven't seen used before. Creating a similar circuit in CMOS wouldn't be easy (for me anyway). Better off just ignoring pin 35 and putting a Pierce oscillator on the substrate -- just like Andy did.
Dan Moore
Portland, Oregon, USA
Portland, Oregon, USA